TULEX IMPACT SQUARE DRIVE ADAPTORS
Impact Square Drive Adaptors are used as a convertor to permit use of sockets with impact wrenches of different square drive sizes i.e. higher or lower. These are available in 1/4″ (6.3 mm), 3/8″ (9.5mm), 1/2″ (12.7mm), 3/4″ (19mm), 1″ (25.4mm), 1.1/2″ (38.1mm) and 2.1/2″ (63.5)
TULEX IMPACT EXTENSION BAR
An Extension Bar is a coupler that helps the operator to reach nuts and bolts located at inaccessible places, or where a driving tool cannot have access to sockets and/or where clearance for operations of driving tool is not available.
TULEX UNIVERSAL JOINTS
Universal Joint is a coupler interposed between Bi-Hex socket and the driving tool. It is useful for tightening nuts located at difficult angular positions, which cannot be reached with standard tools. This is available in 1/4″ (6.35 mm), 3/8″ (9.5 mm), 1/2″ (12.7 mm), 3/4″ (19 mm) and 1″ (25.4 mm) square drives.
TULEX SWIVEL IMPACT SOCKETS / EXTENSION SOCKETS
Tulex Swivel Impact Socket has a swivel joint as a built in feature. These are useful for tightening of nuts located at difficult angular positions, which cannot be reached with standard sockets. These are available in 3/8″ (9.5 mm) and 1/2″ (12.7 mm) square drives to cover nut sizes from 7 mm to 24 mm across flat. Tulex Swivel Impact Extension Sockets are used where requirements of bolt clearance exists.
TULEX QUICK CHANGE ADAPTORS
These are also called as Screw Driver Bit Holders. It has a 3/8″ square drive female on one side and a ¼” Hex Drive female on the other end. It is also available in ½” Square Drive.
It has a spring release shell which retracts to accept the ¼” hex power type bits and Nut Runners. It is available in Black Industrial Rust Resistant Finish. It is ideal for products where positive bit retention is required.
TULEX SINGLE HEX IMPACT EXTENSION SOCKETS
Tulex Single Hex Impact Extesion Sockets are sockets with built in integral extension. These are suitable for impact applications and are available in Single Hex configuration in rigid as well as swivel joint design. These are provided with locking ring and pin. It is available in 100 mm, 150 mm and 200 mm overall lengths in 3/8″ (6.35mm) and 1/2″ (12.7mm) square drives to cover nut across flat sizes 7mm to 27 mm. These are ideal for use in automobile industry.